Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A G code that cannot be commanded during the three-dimensional coordinate conversion modal was issued. The manual's first action is: “Reconsider the program.”
There is no three-dimensional coordinate conversion function. The manual's first action is: “Check the specifications.”
The turning angle at the block seams exceeded the limit during normal line control. The manual's first action is: “Reconsider the program.”
Normal line control was incorrectly set on a linear axis instead of a rotation axis. The manual's first action is: “Set normal line control for a rotation axis.”
The G92 command was issued during normal line control, which is not allowed for that mode. The manual's first action is: “Reconsider the program.”
A normal line direction control command (G40.1/G41.1/G42.1) was issued without valid specifications. The manual's first action is: “Check the specifications. Remove the normal line direction control command from the p…
The NURBS interpolation command was issued without any specifications being set. The manual's first action is: “Check the specifications.”
General precautions for NURBS commands were violated, such as incompatible modes or operations. The manual's first action is: “Check the commands and modes that cannot be used with the NURBS interpolation. Check the r…
A control point was not correctly designated in the NURBS command. The manual's first action is: “Designate the control point following the NURBS command format.”
The number of stages was incorrectly designated in the NURBS command. The manual's first action is: “Designate the number of stages following the NURBS command format.”
An incorrect weight value was specified in the NURBS command. The manual's first action is: “Designate the weight following the NURBS command format.”
An incorrect knot designation was provided in the NURBS command. The manual's first action is: “Designate the knot following the NURBS command format.”
The high-accuracy part command (G61.5) was issued without any specifications. The manual's first action is: “Check the specifications.”
A high-accuracy die command (G61.2/G61.3) was issued without specifications. The manual's first action is: “Check the specifications.”
The high-accuracy mode (G61.1) was issued without any specifications for it. The manual's first action is: “Check the specifications.”