Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Motor current exceeded overload detection for 80% or more of the detection time constant. The manual's first action is: “AR”
The over-regeneration alarm has reached 80% of its threshold level. The manual lists no action for this code.
An external emergency stop signal was received, indicating that 24V is not applied to the CN23 connector. The manual lists no action for this code.
A 25ms power interruption occurred without dropping main circuit voltage, so no alarm triggers. The manual's first action is: “NR”
The power supply is frequently regenerating at its maximum capacity limit. The manual lists no action for this code.
An emergency stop command was received from the NC system. The manual lists no action for this code.
A parameter has been set beyond its allowable range and will remain unchanged. The manual lists no action for this code.
The absolute position counter value is illegal and must be initially set. The manual lists no action for this code.
Overload warning occurs when 80% of the overload 1 alarm level is detected, indicating possible imminent overload if operation continues. The manual's first action is: “PR”
Over regeneration warning indicates that 80% of the regenerative alarm threshold has been reached, signaling potential over-regeneration. The manual lists no action for this code.
Low battery voltage occurs when the battery supplying power to the absolute position detector has dropped below acceptable levels. The manual lists no action for this code.
High-speed rotary counter err happens when a multi-rotation counter with serial detector reports an absolute position compensation failure. The manual lists no action for this code.
MP scale offset error occurs when the offset data read upon power-on in an MP scale detection system contains errors. The manual's first action is: “PR”
MP scale feedback error occurs when excessive deviation is detected between motor end detector and MP scale feedback in an absolute position detection system. The manual lists no action for this code.
Absolute position dislocation happens when the system cannot set the absolute position counter upon power-on due to inconsistent stored data. The manual's first action is: “PR”