Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
An emergency stop signal was input from the PLC. The manual's first action is: “Cancel the signal with a machine switch such as READY.”
The user PLC (ladder sequence) is not running. This error also occurs when an error occurs in the data communication with the remote I/O. The manual's first action is: “Turn ON the PLC ladder RUN switch on the CPU Car…
An emergency stop input signal was received from a remote I/O unit (RIO3). Or, the communication cable with the remote I/O unit (RIO3) is not connected properly. The manual's first action is: “Examine the causes of th…
An emergency stop input signal was received from a remote I/O unit (RIO2). Or, the communication cable with the remote I/O unit (RIO2) is not connected properly. The manual's first action is: “Examine the causes of th…
An emergency stop input signal was received from a remote I/O unit (RIO1). Or, the communication cable with the remote I/O unit (RIO1) is not connected properly. The manual's first action is: “Examine the causes of th…
An external emergency stop input signal was received. (24V is not being applied to the CN23 connector.) The manual's first action is: “Examine the causes of the emergency stop, and remove them.”
An incorrect frame number was received during auxiliary axis communication summary. The manual lists no action for this code.
A CRC error or incomplete reception occurred during auxiliary axis communication summary. The manual lists no action for this code.
An auxiliary axis communication error occurred due to an illegal axis number/type. The manual lists no action for this code.
An incorrect frame number was received during auxiliary axis communication. The manual lists no action for this code.
A CRC error or incomplete reception occurred during auxiliary axis communication. The manual lists no action for this code.
There is an error in the communication between the NC and amplifier. The manual's first action is: “Check whether there is any abnormality in the following : • Cable (Are there any broken wires?) • Cable shield ground…
An error occurred during the auxiliary axis initial communication. The manual's first action is: “Check the auxiliary axis amplifier setting, connection, axis No. in the spindle specification parameters, "No amp" of t…
An error occurred during the program analysis process, and it became impossible to continue. The manual's first action is: “Call the service center with as many details about the operation status as possible.”
A three-dimensional coordinate conversion command was issued in a modal incapable of three-dimensional coordinate conversion. The manual's first action is: “Reconsider the program.”