Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Too many macro call argument type II sets have been issued, exceeding the allowed limit. The manual's first action is: “Reconsider the program.”
The number of macro calls has exceeded the limit specified in the program settings. The manual's first action is: “Reconsider the program and correct it so that the macro calls do not exceed the limit imposed by the s…
An NC statement and a macro statement are present together in the same block of code. The manual's first action is: “Reconsider the program and place the NC statement and macro statement in separate blocks.”
A macro interrupt command was issued but no macro interrupt specifications exist in the program. The manual's first action is: “Check the specifications.”
A macro specification was issued but no such command specifications exist in the program. The manual's first action is: “Check the specifications.”
A coordinate rotation command was issued but no such command specification exists in the program. The manual's first action is: “Check the specifications.”
Both a pattern rotation and coordinate rotation command were specified together in the program. The manual's first action is: “Check the program.”
A pattern rotation command was issued while another pattern rotation command was already active. The manual's first action is: “Check the program.”
A pattern rotation command was issued without any such specifications being provided. The manual's first action is: “Check the specifications.”
Too many variables were defined within one block, exceeding the allowed limit. The manual's first action is: “Correct the program.”
An unavailable variable was referenced in a formula, either on the left or right side. The manual's first action is: “Correct the program.”
The "=" sign was not used when defining a variable in the program. The manual's first action is: “Designate the "=" sign in the variable definition of the program.”
The variable number used exceeds the maximum allowed variable numbers specified in the program. The manual's first action is: “Check the program variable number.”
A variable command was issued without any variable specifications (#). The manual's first action is: “Check the specifications.”
A subprogram was called without being registered in the program. The manual's first action is: “Register the subprogram.”