Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The plane selection horizontal and vertical axes or the A command are missing in the second block of a geometric command. The manual's first action is: “Reconsider the program.”
The second block of a geometric command does not contain a linear movement command. The manual's first action is: “Command G01 in the second geometric block.”
The second block of a geometric command contains an incremental value, which is not allowed. The manual's first action is: “Command the second geometric block with an absolute value.”
The angle difference between two straight lines in a geometric command is less than 1 degree. The manual's first action is: “Correct the geometric angle.”
An arc command was issued with the geometric command, but no arc specifications were provided. The manual's first action is: “Check the specifications.”
A geometric command was issued without any specifications being set. The manual's first action is: “Check the specifications.”
The system cannot create a valid corner R/C movement due to program errors. The manual's first action is: “Reconsider the program.”
A corner rounding or chamfering command was given during G00 or G33 modal operation. The manual's first action is: “Reconsider the program.”
The movement distance in the following block after a corner rounding/chamfering command is shorter than the specified value. The manual's first action is: “Make the corner rounding or chamfering less than the movement…
The movement distance after a corner rounding or chamfering command is shorter than the specified value. The manual's first action is: “Make the corner rounding or chamfering less than the movement distance since this…
The block following a corner rounding/chamfering command is not a movement command. The manual's first action is: “Replace the G01 command by the block succeeding the corner rounding/chamfering command.”
A corner rounding or chamfering command was issued without any corresponding specifications. The manual's first action is: “Check the specifications.”
A mirror image command (G50.1, G51.1) was issued without programmable mirror image specifications. The manual's first action is: “Check the specifications.”
A scaling command (G50, G51) was issued without any scaling specifications being set. The manual's first action is: “Check the specifications.”
The variable name has been duplicated in the program. The manual's first action is: “Correct the program so that the name is not duplicated.”