Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Read forced quit means that an input/output process was interrupted due to a reset event and must be restarted. The manual's first action is: “Carry out input/output again.”
Computer Link error occurs when communication fails during computer link A or B operations with high-speed servers. The manual's first action is: “After resetting, check the cables and power supply of the connected de…
File I/O indicates that the system failed to read a machining program file, and may have damaged stored memory data if not handled properly. The manual's first action is: “Output the program and all other tool data an…
Tape I/O error means there was a failure in reading from or writing to tape devices during macro printing operations. The manual's first action is: “Check the power supply and cable of the connected devices. Check the…
Movement limit occurs when an axis movement starts or ends within a prohibited area designated by the pre-movement stroke check function. The manual's first action is: “Reconsider the axis address coordinate value in …
No check-before-move spec. means that a pre-movement stroke check command was issued without any such function being specified in the program. The manual's first action is: “Check the specifications.”
Local coord set during exp wk co occurs when a local coordinate system is set while in the G54.1 mode, which is not allowed. The manual's first action is: “Reconsider the program.”
No. G54.1 spec. means that a G54.1 command was used without any workpiece coordinate system offset specification being set. The manual's first action is: “Check the specifications.”
G29 and M commands in same block occurs when an M command is issued simultaneously with a G29 command in the same block. The manual's first action is: “An M individual command cannot be issued in a G29 command block a…
G27 and M commands in same block means a G27 command cannot be used with any individual M command within the same program block. The manual's first action is: “An M individual command cannot be issued in a G27 command…
No 2nd 3rd 4th ref-p ret spec. occurs when the system is commanded to return to reference points that are not defined in the program. The manual's first action is: “Check the specifications.”
Return incomplete axis exists when an axis moves without first returning to its reference point. The manual's first action is: “Execute reference point return manually.”
Parameter input error occurs when insufficient or illegal data is entered for a parameter, including invalid addresses or character-string types. The manual's first action is: “Enter the correct parameter input data.”
A parameter input command was issued without any parameter input specifications being set. The manual's first action is: “Check the specifications.”
The plane was changed between the first and second blocks of a geometric command. The manual's first action is: “Change the plane before the geometric command.”