Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The source is positioned outside the boundaries of the L-beam template. The manual's first action is: “Fix the error, then try again.”
The value assigned to the orientation parameter in the L-beam template is invalid. The manual's first action is: “Make sure that the proper value is used to define the orientation parameter, then try again.”
The orientation parameter for the L-beam template is missing in its definition. The manual's first action is: “Insert the orientation parameter in the 'L-beam' template description to fix the error., then try again.”
One or more dimensions of the U-channel are too small or negative. The manual's first action is: “Fix the error, then try again.”
The side wall thickness of the U-channel exceeds the channel’s outside width. The manual's first action is: “Change the side wall thickness to fix the error, then try again.”
The top wall thickness of the U-channel is too thick relative to the channel's outside height. The manual's first action is: “Change the top wall thickness to fix the error. Then try again.”
The length of the source within the U-channel template exceeds its defined limits. The manual's first action is: “Fix the error, then try again.”
The source is positioned outside the U-channel template boundaries. The manual's first action is: “Fix the error, then try again.”
The inside source in the round tube template extends beyond the boundaries of the tube. The manual's first action is: “Fix the error, then try again.”
The length of the outside source in the round tube template is incorrectly defined. The manual's first action is: “Fix the error, then try again.”
The length of the inside source in the round tube template is incorrectly defined. The manual's first action is: “Fix the error, then try again.”
The start or stop angles for the outside source in the round tube template are invalid. The manual's first action is: “Change the start or stop angle for the outside source definition then try again.”
The start or stop angles for the inside source in the round tube template are invalid. The manual's first action is: “Change the start or stop angle for the inside source definition then try again.”
The detector location conflicts with the generic absorber thickness defined in the 'beaker' template. The manual's first action is: “Change the parameters of the source/detector location or/and the total thickness of …
A boundary node is expected between two outer fragments of the beaker description file but it is not joined properly. The manual's first action is: “Two outer contour fragments are joined at a node of the outer contou…