Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The AND-STR instructions are overused. The manual's first action is: “(1)Turn the power OFF then back ON. (2)If the alarm occurs again, initialize the appropriate data in maintenance mode, and then load the data saved…
All 231 error codes of the Yaskawa FS100 Yaskawa FS100 with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
System battery error – System battery is dead The manual's first action is: “Replace the backup battery and run BIOS Setup Utility to reset the time and date.”
Extended RAM error - Extended RAM Failed at address line The manual's first action is: “1. DIMM 2. System board”
Shadow RAM error - Shadow RAM failed at offset The manual's first action is: “System board”
System RAM error - System RAM Failed at offset. The manual's first action is: “1. DIMM 2. System board”
Monitor type error - Monitor type does not match the one specified in CMOS. The manual's first action is: “Load Setup Defaults in BIOS Setup Utility.”
The keyboard controller has failed. The manual's first action is: “System board.”
The system detected an error with the keyboard. The manual's first action is: “Run interactive tests of the keyboard and the auxiliary input device.”
The system detected a stuck key on the keyboard. The manual's first action is: “1. Check the keyboard if it is pressed. 2. Replace the keyboard.”
The hard disk is not working. The manual's first action is: “1. Reset the hard-disk drive. 2. Load Setup Defaults in BIOS Setup Utility. 3. Hard-disk drive. 4. System board.”
All 9 error codes of the LG 130 Series LG 130 Series with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Parameter is under password protection The manual's first action is: “Parameter is under password protection”
Parameter is not changeable during the running The manual's first action is: “Parameter is not changeable during the running”
The system indicates that a parameter cannot be changed. The manual's first action is: “Parameter is not changeable”