Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The door does not move easily or is obstructed due to maximum driving power being set too low; have a specialist dealer check and adjust it. The manual's first action is: “The maximum driving power has been set too lo…
The rational speed sensor is not detecting impulses because the operator system is obstructed; have the operator serviced. The manual's first action is: “Have operator serviced.”
Adjustments were interrupted before completion, and the door can still be operated normally; check adjustments as per page 18. The manual's first action is: “Door can be operated normally. Recheck adjustments if adjus…
The door does not move easily or is obstructed due to programming mode termination or incorrect door position programming. The manual lists no action for this code.
All 10 error codes of the Marantec Synergy 260, 270 garage door operator with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The instrument has an internal memory error. The manual's first action is: “Turn the power for the instrument off, and then turn it back on.”
Alignment has not been completed successfully. The manual's first action is: “Turn the power for the instrument off, and then turn it back on.”
The instrument's encoder system is malfunctioning. The manual's first action is: “Turn the power for the instrument off, and then turn it back on.”
The remote controller has an internal memory error. The manual's first action is: “Turn the power for the remote controller off, and then turn it back on.”
The rotary head is not rotating due to a system issue. The manual's first action is: “Turn the power for the instrument off, and then turn it back on.”
All 5 error codes of the Sokkia SDG1 laser level with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Input characteristic is too steep for the system. The manual's first action is: “Change input characteristic”
Transducer error signal (Low active) indicates a transducer issue. The manual's first action is: “See the Operating Manual for the transducer”
Analogue output signal status has caused a scaling error. The manual's first action is: “Init Err”
Analogue output signal status has exceeded limits. The manual's first action is: “Init Err”