Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Excessive error 2 occurs when motor position at servo OFF deviates beyond set limits from theoretical position. The manual's first action is: “NR”
Excessive error 1 happens when motor position at servo ON deviates beyond set limits from theoretical position, regardless of whether the difference is detected. The manual's first action is: “NR”
Overload 2 occurs when servo current exceeds 95% for one second or spindle load exceeds continuous rating for 30 minutes during operation. The manual's first action is: “NR”
Overload 1 happens when motor or drive unit exceeds 100% overload detection level, regardless of whether standard values are set or not. The manual's first action is: “NR”
NC command mode error occurs when an invalid spindle control mode selection is made, causing consistent or irregular alarms. The manual's first action is: “NR”
Motor overheat alarms when motor or detector temperature protection activates, either before or after operation starts. The manual's first action is: “NR”
C-axis changeover alarm occurs when C-axis control is selected while a high-speed coil is active during coil changeover mode. The manual's first action is: “NR”
Feedback error 2 happens when motor-side and machine-side position data differ excessively, or encoder feedback fails on the spindle. The manual's first action is: “PR”
Feedback error 1 occurs when position or PLG feedback signals from servo or spindle are corrupted due to loose connectors or signal issues. The manual's first action is: “PR”
Detector changeover unit, communication error happens when communication with the detector changeover unit fails during 1-drive unit 2-motor control. The manual's first action is: “PR”
Detector changeover unit, changeover error occurs when motor changeover signals from the detector unit are faulty or disconnected. The manual's first action is: “PR”
Speed excessive deflection 2 happens during constant speed operation when the difference between command and feedback speed exceeds set limits due to heavy cutting load. The manual's first action is: “PR”
Spindle speed overrun occurs when the motor’s feedback speed exceeds the commanded speed or accelerates unexpectedly, even if stopped. The manual's first action is: “PR”
The spindle speed failed to reach 45r/min even when maximum torque was commanded. The manual's first action is: “PR”
The power module's temperature protection function activated due to overheating. The manual's first action is: “PR”