Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A/D converter error detected in current FB detection, with possible repeated errors or no specific abnormality found. The manual's first action is: “PR”
Magnetic pole position detection error because initial magnetic pole creation was incomplete or SP205 is set incorrectly. The manual's first action is: “PR”
Software processing error 2 because software process was not completed within specified time for CPU2. The manual's first action is: “PR”
Software processing error 1 because software process was not completed within specified time, version unchanged, or error repeats. The manual's first action is: “PR”
Memory error 1 detected during power ON self-check of CPU or internal memory. The manual's first action is: “AR”
Axis selection error because the axis No. selection switch setting is incorrect. The manual's first action is: “AR”
Overcurrent alarm occurs because the motor cannot follow due to insufficient tap time constant or excessive loop gains during synchronous tap control. The manual's first action is: “Readjust the tap time constant. Set…
Excessive error alarm occurs due to reverse synchronous tap direction or too short tap time constant. The manual's first action is: “Check the SP193/bit5 setting. 0 = Forward run, 1 = Reverse run”
All 111 error codes of the Mitsubishi Electric MDS-C1 Series AC Servo/Spindle with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
MS bus fault has occurred; reset the bus modules. The manual's first action is: “Reset the bus modules”
Door movement is too stiff, irregular, or blocked due to sensitivity settings being too low; check for obstructions, balance, or broken springs and have it serviced if needed. The manual's first action is: “Check door…
Operator system is overloaded; check the outlet assigned to the operator or power supply. The manual's first action is: “Have the outlet assigned for the operator and/or supplied power checked.”
The current sensor for automatic cut-out is defective; have the operator serviced. The manual's first action is: “Have operator serviced.”
Photo eye sensors are not connected properly, misaligned, or the beam is broken; check wiring and alignment of photo eyes. The manual's first action is: “Check photo eye sensors wiring and connections.”
Excess travel stop has been triggered; have the operator serviced. The manual's first action is: “Have operator serviced.”