Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Excessive motor drive current was detected, possibly causing vibration or no vibration at all. The manual's first action is: “PR”
An axis information data error was detected in communication with the NC. The manual's first action is: “PR”
A communication frame error was detected in data received from the NC. The manual's first action is: “PR”
An illegal parameter was detected in the parameters received from the NC during power-on, affecting SV001–SV065 or SP001–SP384 settings. The manual's first action is: “PR”
Communication between the NC and drive unit was cut off, possibly due to transmission failure. The manual's first action is: “PR”
The movement command data received from the NC exceeded allowable limits. The manual's first action is: “PR”
A communication or CRC error was detected in the data received from the NC to the drive unit. The manual's first action is: “PR”
The power module's overcurrent protection activated, possibly indicating repeatability issues or drive unit failure before READY ON. The manual's first action is: “PR”
The motor detected a rotation speed exceeding its tolerable limit, potentially due to rapid traverse rate or maximum speed settings. The manual's first action is: “PR”
A communication error occurred between the motor end detector or linear scale and the drive unit, possibly due to disconnections or cable interference. The manual's first action is: “PR”
A data error was detected with the motor end detector or linear scale in the linear servo system. The manual's first action is: “PR”
LED deterioration or memory data errors were detected with the motor end detector or linear scale. The manual's first action is: “PR”
A CPU initial error occurred with the motor end detector or linear scale in the linear servo system. The manual's first action is: “PR”
An incremental position data error was detected in the linear scale's relative position detection circuit. The manual's first action is: “PR”
An absolute position data error was detected in the linear scale's detection circuit. The manual's first action is: “PR”