Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Rush relay melted error occurs when the rush resistance short-circuit relay fails to turn OFF. The manual's first action is: “PR”
External contactor melting happens when the external contactor's contact has melted. The manual's first action is: “PR”
Ground fault occurs when the motor power cable contacts the ground (FG). The manual's first action is: “PR”
Watch dog alarm is triggered when the system is not operating normally. The manual's first action is: “AR”
Phase failure indicates a problem with one of the input power phases. The manual's first action is: “PR”
Rush relay error occurs when the rush resistance short-circuit relay fails to turn ON. The manual's first action is: “PR”
Auxiliary regeneration error happens when the auxiliary regenerative transistor remains ON. The manual's first action is: “PR”
Frequency error occurs when the input power frequency exceeds the specified range. The manual's first action is: “PR”
Power module overcurrent occurs when the power module’s overcurrent protection function activates due to excessive current flow. The manual's first action is: “PR”
Instantaneous power failure occurs when a drop in 24VDC power is detected during operation. The manual's first action is: “PR”
Orientation feedback error happens after orientation completion when command and feedback errors exceed parameter settings. The manual's first action is: “PR”
Collision detection 2 occurs when command torque reaches motor maximum torque, triggering collision detection. The manual's first action is: “NR”
Collision detection 1 G1 occurs when disturbance torque exceeds collision detection level during cutting feed (G1) while collision detection is enabled. The manual's first action is: “NR”
Collision detection 1 G0 occurs when disturbance torque exceeds collision detection value during rapid traverse (G0) while collision detection is enabled. The manual's first action is: “NR”
Excessive error 3 happens when current detection fails during an excessive error 1 condition. The manual's first action is: “NR”