Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Checksum error has occurred. The manual's first action is: “Total reset an recalibration necessary”
All 51 error codes of the Endress+Hauser FMI51, FMI52 capacitive level transmitter with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The 4th or 5th notch filter’s valid/invalid setting has been changed from initial configuration. The manual's first action is: “SV087, SV088”
Servo option is unavailable because MP scale absolute position function is set. The manual's first action is: “SV017”
Servo option is unavailable because adaptive filter function is set. The manual's first action is: “SV027”
Servo option is unavailable because SHG control function is set. The manual's first action is: “SV057, SV058”
Servo option is unavailable because closed loop or dual feedback control function is set. The manual's first action is: “SV025, SV017”
Absolute position parameter is valid only when OSE104 and OSE105 are connected. The manual lists no action for this code.
Electronic gears, Position loop gain, or Speed feedback settings are overflowing. The manual's first action is: “Electronic gears, Position loop gain, Speed feedback”
CNC setting for maximum cutting speed is incorrect, possibly due to illegal software. The manual's first action is: “Turn the power ON again.”
CNC setting for maximum rapid traverse rate is incorrect, possibly due to illegal software. The manual's first action is: “Turn the power ON again.”
Over-regeneration level has reached 80% or more. The manual's first action is: “*”
External emergency stop signal was input or use is restricted or permitted based on system configuration. The manual's first action is: “*”
Instantaneous power failure warning means an instantaneous power failure occurred. The manual's first action is: “NR”
Auxiliary regeneration frequency over means regeneration at power supply performance limit is occurring frequently. The manual's first action is: “*”