Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The specified A_BANK number does not exist. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa rep…
A_BANK conversion could not be performed. The manual's first action is: “(1)Reset the alarm, and then try again. (2)If the alarm occurs again, save the CMOS BIN in maintenance mode, and then contact your Yaskawa repre…
The system detected a defective taught point in an endless motion mode. The manual's first action is: “-Checking the command soft (JOB) -MRESET instruction to corresponding axis”
The TWIN DRIVE OVER DEVIATION alarm indicates an axis deviation exceeding limits. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, replace controller. Save the CMOS.BIN before replace c…
The drive belt has snapped or failed. The manual's first action is: “Check that the driving belt is not broken.”
The servofloat execute error indicates a setting error. The manual's first action is: “Check the settings for jobs.”
The LNR SERVOFLOAT TOOL POSE ERROR indicates a setting error. The manual's first action is: “Check the setting file of the job and the linear servo float.”
The LNR SERVOFLOAT COORD TYPE ERROR indicates a setting error in the linear servo float. The manual's first action is: “Check the setting file of the job and the linear servo float.”
The servo float torque limit has been set incorrectly. The manual's first action is: “Check the limit torque of the link servo float condition file.”
The link servo float has reached its torque limit due to a setting error. The manual's first action is: “Check the limit torque of the link servo float condition file.”
LNK SERVOFLOAT EXECUTE ERROR indicates a setting error in the linear servo float configuration. The manual's first action is: “Confirm the job settings so that excess load would not be applied to the axis in the linea…
A software operation error occurred in linear servo float tracking. The manual's first action is: “Confirm the job settings so that excess load would not be applied to the axis in the linear servo float.”
The converter has experienced an overvoltage condition. The manual's first action is: “(1)Reset the alarm.”
The servo tracking error code 4328 indicates an issue with settings or interference affecting the motion control. The manual's first action is: “Check the settings of the following. -Tool file setting -The tools or th…
The motor is rotating in the wrong direction. The manual's first action is: “(1)Reset the alarm. (2)If the alarm occurs again, check the connection and inserting state of the following cables and connectors. -The moto…