Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
The keep warm function has been in use for more than 96 hours. The manual's first action is: “→ Press the "Off" button.”
All 4 error codes of the Panasonic SR-CX108 SR-CN108 SR-CX188 SR-CP188 SR-CN188 electronic rice cooker with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
The drive has displayed an alarm code because data could not be saved during undervoltage protection activation. The manual lists no action for this code.
The drive has displayed an alarm code due to a communication error on the RS485 line. The manual lists no action for this code.
The drive has stopped because the STOP key was pressed, overriding any run commands from terminals or communications. The manual's first action is: “Pressing key on the keypad forces the motor to decelerate and stop e…
The drive has stopped because of a CPU error caused by noise or another factor. The manual lists no action for this code.
The drive has stopped due to a communication error between it and the remote keypad during operation from that keypad. The manual's first action is: “If the drive detects a communication error when the remote keypad i…
Memory error triggered after power-on or during data writing, causing the drive to stop if an error is detected. The manual lists no action for this code.
(Input phase loss) detected input phase loss without a specific cause listed in the provided data. The manual lists no action for this code.
Data save error during undervoltage occurred without a specific cause listed in the provided data. The manual lists no action for this code.
RS485 communications error occurred due to incorrect controller settings/software/hardware, faulty relay converters, or broken/loose communication cables. The manual's first action is: “CHECK Check the controllers. SU…
Operation protection activated when key was pressed with H66 set to 1 or 3, or start check function activated with H66 set to 2 or 3. The manual's first action is: “CHECK Change the setting for H66 so that the STOP ke…
CPU error triggered by high-intensity noise or printed control circuit board malfunction. The manual's first action is: “CHECK Check if appropriate noise control measures have been implemented (e.g. correct grounding …
Remote keypad communications error occurred without a specific cause listed in the provided data. The manual lists no action for this code.
Memory error occurred due to power interruption during data writing, high noise interference, or CPU malfunction. The manual's first action is: “CHECK Check whether pressing the key resets the alarm after the function…