Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A PTP idle travel increment exceeds the maximum allowable value of (2^21 - 1). The manual's first action is: “FF01-0505h”
The homing mode setting (P5.10) is incorrect. The manual's first action is: “FF01-0504h”
Software limits are incorrect because P0.35 is set equal to or less than P0.36. The manual's first action is: “FF01-0503h”
The motor and drive models do not match, as P0.00 is set incorrectly. The manual's first action is: “FF01-0502h”
The motor model does not exist in the system settings. The manual's first action is: “FF01-0501h”
System initialization failed due to one or more self-check items failing after power-on. The manual's first action is: “FF01-0400h”
The current sensor for Phase-W has failed without specified cause. The manual's first action is: “7300-0302h”
The current sensor for Phase-V has failed because the motor shaft is powered on in a non-static state. The manual's first action is: “7300-0301h”
The current sensor for Phase-U has failed due to an abnormality in the sensor or detection circuit. The manual's first action is: “7300-0300h”
A data check error occurred during an attempt to read from the encoder’s EEPROM on startup. The manual's first action is: “7300-020Dh”
No valid data was found in the encoder’s EEPROM upon power-on, indicating a communication issue with the encoder. The manual's first action is: “7300-020Ch”
An EEPROM writing error occurred during data transmission or check when updating the encoder’s EEPROM. The manual's first action is: “7300-020Bh”
The encoder is overheating due to its battery voltage being between 2.5V–3.0V. The manual's first action is: “7300-020Ah”
The encoder’s external battery voltage is too low, triggering an undervoltage fault and requiring battery replacement. The manual's first action is: “7300-0209h”
The encoder’s external battery voltage is low (between 3.0V–3.2V), requiring replacement of the battery. The manual's first action is: “7300-0208h”