Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Position deviation fault occurs when server response is too slow causing residual pulses to exceed P4.33, or due to heavy load stalling. The manual's first action is: “8500-1600h”
Position overtravel—CW occurs when CW limit switch is touched, accumulated pulses exceed P0.36, or pulse frequency exceeds motor speed. The manual's first action is: “FF01-1501h”
Position overtravel—CCW occurs when CCW limit switch is touched or accumulated feedback pulse exceeds P0.35 setting. The manual's first action is: “FF01-1500h”
Speed deviation fault occurs when motor speed deviates from command in non-torque mode, possibly due to phase reversal. The manual's first action is: “8400-1400h”
Speed fault—Overspeed parameter set incorrectly occurs when P4.40 is less than 0 or P4.41 is greater than 0. The manual's first action is: “7180-1303h”
Speed fault—CW overspeed occurs when feedback speed exceeds P4.41 by more than 20ms in CW direction. The manual's first action is: “7180-1302h”
Speed fault—CCW overspeed occurs when feedback speed exceeds P4.40 by more than 20ms in CCW direction. The manual's first action is: “7180-1301h”
Speed fault—Overspeed occurs when motor speed exceeds P4.32 setting, possibly due to stalling or phase reversal. The manual's first action is: “7180-1300h”
Motor overtemperature occurs when the motor temperature exceeds its overheating protection threshold. The manual's first action is: “2310-1201h”
Motor overload occurs during long-term or short-term excessive motor loading. The manual's first action is: “2310-1200h”
Drive overload occurs when short-term load exceeds capacity. The manual's first action is: “FF01-1100h”
Main circuit undervoltage occurs when the DC voltage is too low, possibly due to low grid voltage or an open buffer relay. The manual's first action is: “3120-0D01h”
Main circuit overvoltage occurs when the DC voltage of the main circuit is higher than set, possibly from grid voltage or internal circuit damage. The manual's first action is: “3110-0D00h”
I/O fault—Pulse input frequency too high occurs when the detected pulse input frequency exceeds the specified limit, often due to an external signal being too fast. The manual's first action is: “FF01-0C02h”
I/O fault—Duplicate AI assignment occurs when analog input 3 is configured as a speed command in standard drive mode. The manual's first action is: “FF01-0C01h”