Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Communication to the higher-level controller, including internal coupling or PROFIBUS/PROFINET, is faulted or interrupted on the Siemens G120C drive. The manual's first action is: “Check the state of the higher-level …
The motor was operated outside permissible limits, such as temperature, current, or torque, on the Siemens G120C drive. The manual's first action is: “Check the load cycles and set limits. Check the ambient temperatur…
A ground fault or inter-phase short-circuit was detected in power cables or motor windings on the Siemens G120C drive. The manual's first action is: “Check the power cables (connection). Check the motor.”
The temperature in an electronic component has exceeded its highest permissible limit on the Siemens G120C drive. The manual's first action is: “Check the ambient temperature / control cabinet ventilation.”
An impermissible operating state of the power electronics, such as overcurrent or IGBT failure, was detected on the Siemens G120C drive. The manual's first action is: “Check compliance with the permissible load cycles…
The DC-link voltage has exceeded an inadmissible high value on the Siemens G120C drive. The manual's first action is: “Check the dimensioning of the system (line supply, reactor, voltages). Check the infeed settings.”
An electronics supply voltage fault, like 48 V, 24 V, or 5 V, was detected on the Siemens G120C drive. The manual's first action is: “Check the wiring. Check the voltage level.”
A line supply fault has occurred, such as phase failure or voltage level issues, on the Siemens G120C drive. The manual's first action is: “Check the line supply and fuses. Check the supply voltage. Check the wiring.”
A hardware or software malfunction was detected on the Siemens G120C drive. The manual's first action is: “Carry out a POWER ON for the relevant component. If it occurs again, contact the hotline.”
All 106 error codes of the Siemens G120C Siemens G120C drive with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
PDO data lost during EtherCAT communication on the INVT DA180. The manual lists no action for this code.
Disconnection occurred in EtherCAT communication on the INVT DA180. The manual lists no action for this code.
DC Sync0 signal exception occurred during EtherCAT communication on the INVT DA180. The manual lists no action for this code.
EEPROM fault detected on the INVT DA180 EtherCAT communication. The manual lists no action for this code.
EtherCAT initialization fault detected on the INVT DA180. The manual lists no action for this code.