Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
I/O fault—Duplicate digital input assignment occurs when two or more digital inputs are configured with the same function. The manual's first action is: “FF01-0C00h”
Software fault—Illegal operation occurs without specified causes in this product. The manual's first action is: “6100-0B02h”
Software fault-Periodic task re-entry happens without specified causes in this product. The manual's first action is: “6100-0B01h”
Software fault-Motor control task re-entry occurs when the DSP CPU utilization is too high or has bugs. The manual's first action is: “6100-0B00h”
RS485 communication is disrupted due to strong EMI interference. The manual's first action is: “4458-0A05h”
An emergency stop fault occurred when the configured emergency stop digital terminal activated. The manual's first action is: “4458-0A04h”
An external input fault occurred when a configured digital terminal acted as an external fault input. The manual's first action is: “5544-0A03h”
A motor cable (V or W) is shorted to ground, detected during power-on. The manual's first action is: “5544-0A02h”
The external communication card is faulty. The manual's first action is: “5544-0A01h”
The FPGA on the control board has reported a hardware fault. The manual's first action is: “5544-0A00h”
EEPROM data check error occurred because read data differs from written data or the DSP version was updated. The manual's first action is: “5530-0901h”
EEPROM read/write operations failed due to data damage or writing disturbance. The manual's first action is: “5530-0900h”
The voltage input to AI 2 exceeds the limit set by P3.25. The manual's first action is: “5442-0801h”
The voltage input to AI 1 exceeds the limit set by P3.22. The manual's first action is: “5441-0800h”
Regeneration discharge overload occurs due to low brake resistor power, high motor speed, or rapid deceleration. The manual's first action is: “7100-0700h”