Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
Cancel Report Code is sent upon disarming after an alarm condition was reported. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and required for residential fire alarm instal…
RF Trans. Low Batt. Report Code is sent when a wireless transmitter has a low-battery condition. The manual's first action is: “UL installations: must be enabled if wireless devices are used.”
Arm Away/Stay Report Code allows independent programming of Away and Stay reports for each partition, including lobby. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and requ…
Open Report Code is sent upon disarming of the system in selected partitions. The manual's first action is: “UL: Required for UL commercial burglar alarm installations.”
Test Report Code is sent periodically to verify communicator and phone line functionality, with frequency set via scheduling or key commands. The manual's first action is: “installer code + [#] + 0 + 0 = test report s…
Low Bat Report Code indicates a low-battery condition in the system's main battery. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and required for residential fire alarm ins…
AC Loss Report Code is sent randomly with up to 4-hour delay if AC power fails, and no report occurs if AC restores before it goes out. The manual's first action is: “UL: Required for UL commercial burglar alarm insta…
Bypass Report Code is triggered when a zone is manually bypassed. The manual's first action is: “UL: Required for UL commercial burglar alarm installations.”
Trouble Report Code is sent when a zone has a trouble condition. The manual's first action is: “UL: Required for UL commercial burglar alarm installations and required for residential fire alarm installations.”
Exit Error Report Code indicates an alarm sound when entry/exit or interior zone remains open after the Exit Delay time expires while system is armed. The manual's first action is: “If the system is not disarmed befor…
All 60 error codes of the KOPPEL K5305-1V1 security system control panel with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
Table problem occurred. The manual lists no action for this code.
SRQ is stuck in ON position. The manual lists no action for this code.
Serial poll status byte queue overflowed. The manual lists no action for this code.
GPIB bus error occurred. The manual lists no action for this code.