LS Mecapion L7P INDEXER Series Error Codes

33 codes from pages 192–275 of the manual

This is the list of warning, error codes the LS Mecapion manual gives for the L7P INDEXER Series AC servo. Find your code below and open it for what the manual says about its causes and what to do.

Warning codes from p. 275

CodeWhat it meansPage
W01 Main power fail p. 275
W02 Encoder battery low p. 275
W04 Softwarepositionlimit p. 275
W08 Excessive DB current p. 275
W10 Operation overload p. 275
W20 Abnormal drive/motor combination p. 275
W40 Low voltage p. 275
W80 Emergency signal input p. 275

Error codes from p. 269

CodeWhat it meansPage
AL10 IPM fault (Overcurrent/H/M) p. 269
AL14 Over current (Overcurrent/S/W) p. 269
AL16 Current limit exceeded (Overcurrent/H/M) p. 269
AL11 Regeneration overload IPM temperature p. 269
AL15 Current offset p. 269
AL021 Continuous overload p. 270
AL-25 Drive temperature 2 p. 271
AL-26 Encoder temperature p. 271
AL-30 Encoder communication p. 271
AL-31 Encoder cable open p. 271
AL-32 Encoder data p. 271
AL-33 Motor setting p. 271
AL-34 Encoder setting p. 271
AL-35 Low battery p. 271
AL-36 Sinusoidal ENC p. 271
AL-37 Sinusoidal ENC frequency p. 272
AL-38 Z phase open p. 272
AL-40 Under voltage p. 272
AL-41 Over voltage p. 272
AL-42 Main power fail p. 272
AL-43 Control power fail p. 273
AL-50 Over speed limit p. 273
AL-51 POS following p. 273
AL-53 Excessive SPD deviation p. 273
AL-54 Encoder2 POS difference p. 273

Codes and descriptions are taken from the manufacturer’s manual; page numbers link to the PDF. ManualLib is not affiliated with LS Mecapion. Found a mistake? Report an error.