LS Mecapion L7P INDEXER Series Error AL-34: Encoder setting

AC servo · taken from the manufacturer’s manual, pages cited

Error codeAL-34

Encoder setting error due to incorrect wiring, encoder malfunction, or drive issue. The manual's first action is: “Wiring Is Incorrect and check Short. Replace encoder cable.”

Model
LS Mecapion L7P INDEXER Series
Display shows
Encoder setting (AL-34)
Type
Error code
Source
Manual p. 271

What AL-34 means

Encoder setting p. 271

Common causes

What to do

  1. Wiring Is Incorrect and check Short. Replace encoder cable. p. 271
  2. If alarm continue after servo on again, Replace drive. Because drive may have problem. p. 271

If AL-34 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact LS Mecapion service.

Open the manual at page 271 All L7P INDEXER Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about AL-34; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with LS Mecapion. Found a mistake? Report an error.