LS Mecapion L7P INDEXER Series Error AL16: Current limit exceeded (Overcurrent/H/M)

AC servo · taken from the manufacturer’s manual, pages cited

Error codeAL16

Drive error, Error by noize The manual's first action is: “Determine whether there is a conflict or binding in the equipment.”

Model
LS Mecapion L7P INDEXER Series
Display shows
Current limit exceeded (Overcurrent/H/M) (AL16)
Type
Error code
Source
Manual p. 269

What AL16 means

Current limit exceeded (Overcurrent/H/M) p. 269

Common causes

What to do

  1. Determine whether there is a conflict or binding in the equipment. p. 269
  2. Check method to improve noise of wiring, install. p. 269

If AL16 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact LS Mecapion service.

Open the manual at page 269 All L7P INDEXER Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about AL16; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with LS Mecapion. Found a mistake? Report an error.