LS Mecapion L7P INDEXER Series Error AL14: Over current (Overcurrent/S/W)

AC servo · taken from the manufacturer’s manual, pages cited

Error codeAL14

Parameter cable error, Check motor phase resistor The manual's first action is: “Motor ID [0x2000], encoder type[0x201], encoder form[0x202] setting vaule should be same with applied to motor label.”

Model
LS Mecapion L7P INDEXER Series
Display shows
Over current (Overcurrent/S/W) (AL14)
Type
Error code
Source
Manual p. 269

What AL14 means

Over current (Overcurrent/S/W) p. 269

Common causes

  • Parameter cable error p. 269
  • Check motor phase resistor p. 269

What to do

  1. Motor ID [0x2000], encoder type[0x201], encoder form[0x202] setting vaule should be same with applied to motor label. p. 269
  2. Check if U/V/W phase currentoffset[0x2015~0x2017] is 5% or above of the rated current, Replace drive p. 269

If AL14 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact LS Mecapion service.

Open the manual at page 269 All L7P INDEXER Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about AL14; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with LS Mecapion. Found a mistake? Report an error.