LS Mecapion L7P INDEXER Series Error W10: Operation overload

AC servo · taken from the manufacturer’s manual, pages cited

Warning codeW10

Accumulated operation overload ratio reached the warning level (0x2010). The manual's first action is: “Check for equipment clash or arrest. Check load status, brake action, drive output miss wiring, encoder miss wiring. Check motor ID, drive ID, encoder setting”

Model
LS Mecapion L7P INDEXER Series
Display shows
Operation overload (W10)
Type
Warning code
Source
Manual p. 192

What W10 means

Operation overload p. 275

Common causes

  • Accumulated operation overload ratio reached the warning level (0x2010). p. 275

What to do

  1. Check for equipment clash or arrest. Check load status, brake action, drive output miss wiring, encoder miss wiring. Check motor ID, drive ID, encoder setting p. 275

If W10 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact LS Mecapion service.

Open the manual at page 192 All L7P INDEXER Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about W10; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with LS Mecapion. Found a mistake? Report an error.