LS Mecapion L7P INDEXER Series Error W08: Excessive DB current

AC servo · taken from the manufacturer’s manual, pages cited

Warning codeW08

DB current exceeding the fault level was output The manual's first action is: “DB current exceeding the fault level was output”

Model
LS Mecapion L7P INDEXER Series
Display shows
Excessive DB current (W08)
Type
Warning code
Source
Manual p. 192

What W08 means

Excessive DB current p. 275

Common causes

  • DB current exceeding the fault level was output p. 275

What to do

  1. DB current exceeding the fault level was output p. 275

If W08 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact LS Mecapion service.

Open the manual at page 192 All L7P INDEXER Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about W08; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with LS Mecapion. Found a mistake? Report an error.