LS Mecapion L7P INDEXER Series Error W04: Softwarepositionlimit

AC servo · taken from the manufacturer’s manual, pages cited

Warning codeW04

When using software position limit function, position command larger than the software position value was input. The manual's first action is: “When using software position limit function, position command larger than the software position value was input.”

Model
LS Mecapion L7P INDEXER Series
Display shows
Softwarepositionlimit (W04)
Type
Warning code
Source
Manual p. 192

What W04 means

Softwarepositionlimit p. 275

Common causes

  • When using software position limit function, position command larger than the software position value was input. p. 275

What to do

  1. When using software position limit function, position command larger than the software position value was input. p. 275

If W04 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact LS Mecapion service.

Open the manual at page 192 All L7P INDEXER Series error codes Manual details & download

This page summarises what the manufacturer’s manual says about W04; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with LS Mecapion. Found a mistake? Report an error.