Industrial

The GLT41316 is a 65,536 x 16-bit high-performance CMOS dynamic random access memory from G-Link Technology Corporation. It features Fast Page mode, and has both BYTE WRITE and WORD WRITE access cycles via two WE pins. It has symmetric address and accepts 256-cycle refresh in 4ms interval. All inputs are TTL compatible. Fast Page Mode operation allows random access up to 256x16 bits, within a page, with cycle times as short as 18ns. The GLT41316 is best suited for graphics, and DSP applications requiring high performance memories.

95 X O F1400A Series 9x14 mm FR-4, 5.0 Volt, Sinewave, Clock Oscillator Pin Connections • Former Product OBSOLETE

The XTR106 4-20mA current transmitter with Bridge Excitation and Linearization has low total unadjusted error, 2.5V or 5V bridge excitation reference, 5.1V regulator output, low span drift: ±25ppm/°C max, low offset drift: 0.25µV/°C, high PSR: 110dB min, high CMR: 86dB min, wide supply range: 7.5V to 36V, and is used in pressure bridge transmitters, strain gage transmitters, temperature bridge transmitters, industrial process control, SCADA remote data acquisition, remote transducers, weighing systems, and accelerometers.

The P83C557E6/P80C557E6 is a single-chip 8-bit microcontroller produced by Philips. It features an 80C51 central processing unit, 48K × 8 ROM, 1536 × 8 RAM, two standard 16-bit timer/counters, a 10-bit ADC, two 8-bit resolution, pulse width modulation outputs, five 8-bit I/O ports, an I2C-bus serial I/O port, full-duplex UART, on-chip watchdog timer, 15 interrupt sources, 2 priority levels, 4.5 to 5.5 V power supply range, 3.5 MHz to 16 MHz frequency range, PLL oscillator, 32 kHz reference and software-selectable system clock frequency, seconds timer, software enable/disable of ALE output pulse, electromagnetic compatibility improvements, wake-up from power-down by external or seconds interrupt

This document introduces the features and characteristics of the AQV251 series optocoupler isolation relay, including high sensitivity, low on-resistance, multiple load types, extremely high isolation voltage, low leakage current in the off state, and no need for a power supply to drive the power MOSFET.

The document describes a parametric measurement unit with functions to measure voltage and current. It has a voltage range of -5V to +15V, four programmable current ranges, high resolution, and high accuracy.

The XTR112 and XTR114 are monolithic 4-20mA, two-wire current transmitters. They provide complete current excitation for high impedance platinum RTD temperature sensors and bridges, instrumentation amplifier, and current output circuitry on a single integrated circuit.

This document contains information on a product under development at Advanced Micro Devices. The product is a flash memory with features such as simultaneous read/write operations, single power supply operation, high performance, and low current consumption.

The LT ®1635 is a new analog building block that includes a rail-to-rail output op amp, a precision reference and reference buffer. The device operates from supplies as low as a single 1.2V or up to ±5V, yet it consumes only 130µA of supply current. The input common mode range of the op amp includes ground and incorporates phase reversal protection to pre- vent false outputs from occurring when the input is below the negative supply. The rail-to-rail output stage can swing to within 15mV of each rail with no load and can swing to within 250mV of each rail while delivering 10mA of output current. The gain bandwidth of the op amp is 175kHz and it is unity- gain stable with up to 1000pF load capacitance. The 0.2V reference is referred to V– and includes a buffer amplifier to enhance flexibility. The reference and buffer combine to achieve a drift of 30ppm/°C, a line regulation of 20ppm/V and a load regulation of 150ppm/mA. The LT1635 is available in 8-pin PDIP and SO packages, and has the industry standard LM10 pinout.

The STW80NF10 is a low gate charge N-channel MOSFET from STMicroelectronics. It features a typical RDS(on) of 0.012 ohms and excellent dv/dt capability, making it suitable for use in high-efficiency DC-DC converters and UPS and motor control applications.

EM83702 Mouse Controller is specially designed to control mouse device. It can be directly interfaced to RS-232C and does not need any external power supply. It is versatile with both microsoft and mouse system.

This document introduces the features of XM28C040, including high density, 4 megabits, 512Kx8, access time, base memory component, pinout, fast write cycle times, early end of write detection, data polling, toggle bit polling, software data protection, three temperature ranges, high reliability modules, all components are MIL-STD-883 compliant, endurance.

This datasheet lists the specifications of recom company's recoline dc/dc-converter products, including input voltage, output voltage, output current, full load current, no load current, efficiency, etc.

AD5346/AD5347/AD5348 are a series of parallel interface octal voltage output 8-/10-/12-bit DACs with a voltage range of 2.5 V to 5.5 V. They feature low power operation, guaranteed monotonicity, rail-to-rail output range, power-on reset to 0 V, etc.