Industrial

This document is powered by ICminer.com Electronic-Library Service Copyright 2003. It provides information on the features and characteristics of the products.

XIO2000A is Texas Instruments' PCI Express bridge chip, designed for seamless migration from legacy PCI to the PCI Express interface. The chip supports PCI Express rates of 2.5 Gbps and PCI 2.3 interface. XIO2000A enables PC and I/O add-on card manufacturers to begin transitioning to native PCI Express technology while preserving compatibility with existing PCI system software and firmware.

This document is provided by ICminer.com Electronic-Library Service. Copyright 2003. The document describes the features and characteristics of the ICminer.com Electronic-Library Service.

This document describes the features and characteristics of the ICminer.com Electronic-Library Service. The service provides users with access to a digital library of electronic books and documents. The copyright of this service belongs to ICminer.com.

This document is a copyright statement about the ICminer.com Electronic-Library Service. The service started in 2003 and provides electronic library services.

The LTC1562 is a low noise, low distortion continuous-time filter with ±5V single supply or ±5V/±10V dual supply, 10kHz to 150kHz center frequency, 4 independent 2nd order filter blocks, resistor-programmable center frequency, Q and gain.

The LTC ®1483 is an ultra-low power differential line trans- ceiver designed for data transmission standard RS485 applications with extended common-mode range (–7V to 12V). It will also meet the requirements of RS422. The LTC1483 features output drivers with controlled slew rate, decreasing the EMI radiated from the RS485 lines, and improving signal fidelity with misterminated lines. The CMOS design offers significant power savings over its bipolar counterparts without sacrificing ruggedness against overload or ESD damage. Typical quiescent current is only 80µA while operating and less than 1µA in shutdown. The driver and receiver feature three-state outputs, with the driver outputs maintaining high impedance over the entire common-mode range. Excessive power dissipation caused by bus contention or faults is prevented by a thermal shutdown circuit which forces the driver outputs into a high impedance state. The receiver has a fail-safe feature which guarantees a high output state when the inputs are left open. I/O pins are protected against multiple ESD strikes of over ±10kV. The LTC1483 is fully specified over the commercial and extended industrial temperature range and is available in 8-pin DIP and SO packages.

The AK10 series of high current transient suppressors are specially designed for use in A.C. Line Protection and any demanding applications (AC or DC). They offer superior clamping factor with Foldbak™ technology. Glass passivated junction, Bi-directional, Ultra Compact: 12 times less volume than traditional discrete solutions. Very Low Clamping Voltage, Sharp Breakdown Voltage, Low Slope Resistance.

This product is a high-performance floating-point digital signal processor (DSP)

The document describes the features and characteristics of CTS Electronic Components, Inc.'s Model 575 Temperature Compensated Crystal Oscillator, including size, output waveform, frequency range, frequency stability, operating voltage, operating temperature range, etc.

The AIC1734 is a 300mA low dropout linear regulator from Analog Integrations Corporation. It features ultra-low dropout, zero base current loss, 2% accuracy output voltage, etc.