Industrial

ACT1100/1700 series crystal oscillators are high-precision crystal oscillators with frequency range from 500KHz to 125MHz, working temperature range from 0-70°, working voltage 3.3V/5.0V, output current 15mA/25mA and output logic TTL/HCMOS

This document introduces a product with RF input of 15dB and RF output of 12dB, which has high gain and low noise characteristics.

This is a data sheet for A-BRIGHT AB-46TR-6VD-T5 single lamp LED bulb. The bulb uses high efficiency LED materials and has the features of super brightness, wide viewing angle, seven colors, solid-state, vibration resistance, energy saving and long life.

The AAT602 is a high-precision reset voltage detector that provides a high-precision output signal, which allows users to initiate or reset the system. The detection voltage with an accuracy of ±2% is trimmed to customized specification. Delay time can be adjusted by an external capacitor. And output signal may be configured as either open drain or push-pull. With minimal external components required, the AAT602 offers a simple and economical solution.

The AAT3216 MicroPower™ Low Dropout Linear Regulator is ideally suited for portable applications where low noise, extended battery life and small size are critical.

ADG811/ADG812/ADG813 are low voltage CMOS devices containing four independent SPST switches with low resistance and fast switching times.

This document describes the features and specifications of the AA20C power supply, including 20 watts single output, 2:1 input range, operating temperature range of -40°C to +105°C, etc.

This document is a list of TOKO D10F series inductors, including rated inductance, frequency, DC resistance, DC current, etc.

The document provides information about the voltage and power ratings of the SEMICONDUTORES LTDA. AEGIS A5N:300.XXH product.

AMP-TRAP®–Form 101 A50P Semiconductor Protection Fuses were developed for DC drives, uninterruptable power supplies and similar applica- tions requiring better protection (lower l2t) and superior reliability. The A50P is typically used for replacement.

The document describes the features and characteristics of the ATF20V8B high-performance CMOS programmable logic device (PLD), including industry-standard architecture, high-speed electrically erasable programmable logic devices, several power saving options, CMOS and TTL compatible inputs and outputs, etc.

The ATF-10136 is a GaAs FET with a low noise figure of 0.5 dB, a low bias of 20 mA, a gain of 13 dB, and an output power of 20 dBm. It is housed in a 36 micro-X package and is available with tape and reel packaging.

A426316B Series is 64K x 16 CMOS Dynamic RAM with EDO page mode. This series has high speed, low power consumption, separate CAS (UCAS, LCAS) for byte selection, self refresh mode, 256 refresh cycles, 4 ms refresh interval, read-modify-write, RAS-only, CAS-before-RAS, hidden refresh capability, TTL-compatible, three-state I/O, JEDEC standard packages (400mil, 40-pin SOJ-400mil, 40/44 TSOP type II package), single 5V power supply/built-in VBB generator.

The Turbo IC 24C64 is a serial 64K EEPROM manufactured by Turbo IC using Turbo's proprietary high reliability and high performance CMOS technology.

C10 2mm Pitch Miniature Connector A3 • A4 Series is a connector made by Hioki that features a small, lightweight design and high-density mounting. The connector supports DIP, SMT, and crimp types, and can be stacked as needed.