User manual for the Optoma 3D-RF emitter and shutter glasses: connection to the 3D-XL converter box, RF sync, LED modes, pairing, polarity and tuning.
This user manual describes the Optoma 3D-RF System, consisting of Optoma 3D-RF Shutter Glasses and the Optoma 3D-RF Emitter. It explains how the emitter connects to the Optoma 3D-XL converter box through the IR Emitter Port and controls the glasses through RF synchronization.
The document covers LED indicators, joystick operation, modes of operation, pairing, manual performance tuning, delay tuning, lens duty cycle tuning, and polarity settings. It also includes warnings about eyestrain during manual tuning and notes about factory reset behavior.
| LED indicators | 5 multicolored LEDs |
|---|---|
| Modes of operation | 5 |
| Joystick | Two axes and a center button |
| Delay settings | 20 possible visible values |
| Set Polarity mode timeout | 10 seconds |
| Manual performance tuning timeout | Two minutes after joystick inactivity |
| Normal mode inactivity timeout | 60 seconds |
| Polarity setting save delay | 120 seconds |
Connect it to the converter box using the IR Emitter Port.
They show a red moving pattern until a 3D signal is found.
If three red LEDs are lit, the polarity is reversed.
It stays active for two minutes after joystick operation stops, then the settings are saved and the emitter returns to normal mode.