This guide explains how to install and configure the SUNSTAR CC406H security control panel. It covers technical specifications, wiring, programming methods, arming modes, bypass zones, and troubleshooting.
Key sections include technical specifications, programming via keyboard or remote, normal and forced arming, perimeter (STAY) mode, factory reset procedures, installer commands, and special functions such as fault analysis and test report generation. This manual is written in Chinese.
| Operating temperature | 0°C—+49°C |
|---|---|
| Input power | 16V AC, 20V A 50/60Hz |
| Maximum load current | 13.8VDC, 700mA (max) |
| Alarm output power | 13.8VDC, 400mA (max) |
| Programmable output (PGM) power | 13.8VDC, 100mA (max) |
| Backup battery capacity | 7.2Ah (max) |
| Anti‑tamper resistor | 1.5kΩ 0.25W |
Use installer mode with the installer password and enter +A W A Y +961+ AWAY, or short JP2 on the board after power is removed.
Enter the user password and press the AWAY key; the system will emit two beeps and the AWAY indicator will light.
Forced arming is used when some zones are not ready; press the AWAY key and the system will arm even if zones are not prepared.