Dell OpenManage Management Pack for vRealize Operations Manager 1.2 Installation Guide

The OpenManage Management Pack for vRealize Operations Manager allows you to monitor the health status and analyze important metrics of the Dell EMC PowerEdge servers and chassis that are managed by OpenManage Integration for VMware vCenter (OMIVV) 4.0 or later.


Dell OpenManage Management Pack for vRealize Operations Manager 1.2 Installation Guide - cover page
Brand
DELL
Category
Other software
Document type
Installation Guide
Language
English
Pages
9
File format
PDF
File size
78 KB
Published
26 November, 2023
Updated
26 November, 2023
MD5 checksum
5D6758FDA05760C5FB178DBB9D265DE4

About this manual

The Dell OpenManage Management Pack for vRealize Operations Manager version 1.2 lets you monitor the health status and analyze metrics of Dell EMC PowerEdge servers and chassis managed by OpenManage Integration for VMware vCenter (OMIVV) 4.0 or later. The guide describes prerequisites, the support matrix, configuring OMIVV, installing or upgrading the management pack, adding or removing OMIVV instances, and troubleshooting.

The installation guide covers enabling extended monitoring and SNMP trap monitoring in OMIVV, uploading the OpenManageAdapter .pak file in vRealize Operations Manager, and configuring adapter instances. It also notes that data and alerts populate after three collection cycles.

What's inside

  • Introduction
  • Prerequisites
  • Support Matrix
  • Configuring OMIVV
  • Installing or upgrading to OpenManage Management Pack for vRealize Operations Manager v1.2
  • Adding OMIVV instance
  • Removing OMIVV instances
  • Troubleshooting

Specifications

Required vROPS version6.5 or later
Required OMIVV version4.0 or higher
Supported PowerEdge server generations in management pack 1.212, 13, 14
Supported chassisM1000e, FX2s, VRTX, MX7000
Default data collection cycle5 minutes
Recommended collection interval when OMIVV manages more than 100 servers30 minutes
Minimum iDRAC firmware for 12th and 13th generation PowerEdge servers2.40.40.40 or later
Minimum iDRAC firmware for 14th generation PowerEdge servers3.00.00.00 or later

Frequently asked questions

What versions of vRealize Operations Manager and OMIVV are required?

The management pack requires vRealize Operations Manager 6.5 or later and OMIVV 4.0 or higher.

How do I enable extended monitoring in OMIVV?

In the OMIVV administration console, go to APPLIANCE MANAGEMENT, edit the EXTENDED MONITORING section, and click Enable.

How often does the management pack collect data by default?

By default, a data collection cycle runs every 5 minutes, and data and alerts populate after three collection cycles.

What must I do after upgrading from version 1.0 to 1.2?

For each adapter instance, click Stop Collecting and then Start Collecting in the Solution Details tab.

Why do some storage controllers show an Unknown health status?

On-board controllers, 6GBps SAS HBAs, and Software RAID do not have real-time monitoring support, so their health status is shown as Unknown.

Download PDF (78 KB)

More DELL Manuals


View all DELL manuals →