This manual introduces the operation of dIXEL XR60CX temperature controller, including installation, operation and parameter setting.
This is the Chinese installation and use manual for the Dixell XR60CX, a micro electronic temperature controller measuring 32 x 74 x 60 mm, intended for medium and low temperature forced-air refrigeration systems. It has three outputs (compressor, evaporator fan and defrost) and accepts NTC or PTC probes for cabinet temperature and evaporator temperature, plus a configurable digital input or third probe.
The manual covers load output control, keypad and LED indicator operation, stored maximum and minimum temperatures, parameters, digital input, the TTL serial communication interface for monitoring systems, the optional X-REP remote display, mounting, electrical connections, the programming (hot) key, alarms, technical specifications, wiring diagrams and the parameter table with factory settings. This manual is written in Chinese.
| Dimensions | 32 x 74 x 60 mm |
|---|---|
| Outputs | 3 outputs: compressor, evaporator fan, defrost (electric or hot gas) |
| Probe inputs | Three NTC or PTC probe inputs (cabinet, evaporator, configurable) |
| Optional fourth probe input | Connected to terminals 2 and 4 of the 5-pin hot key connector (NG6-K connector, ordered separately) |
| Communication | TTL serial interface; ModBUS-RTU network via optional XJ485-CX module |
| Defrost modes | tdF = EL electric defrost, tdF = in hot gas defrost |
It controls a compressor, an evaporator fan and a defrost output (electric or hot gas) in forced-air refrigeration systems.
The controller measures 32 x 74 x 60 mm.
In normal (non-programming) mode press the defrost key; this is only possible if the evaporator probe value is below the dtE parameter setting.
Yes, the hot key port can be used with an XJ485-CX communication module to connect to a ModBUS-RTU compatible network such as the DIXELL XWEB monitoring systems.