Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
A tool compensation number was missing or invalid when issuing a radius compensation command, violating specification requirements. The manual's first action is: “Add the compensation number command to the compensatio…
Backward movement was attempted without the system supporting backward motion specifications. The manual's first action is: “Check the specifications.”
A fixed cycle command was executed while in radius compensation mode, which is not allowed and requires cancellation of compensation first. The manual's first action is: “The radius compensation mode is established wh…
A three-dimensional compensation command was issued without the system supporting such functionality. The manual's first action is: “Check the specifications.”
A tool radius compensation error occurred due to interference during execution of a compensation command. The manual's first action is: “Reconsider the program.”
An interference occurred while executing a tool radius compensation command when an intersection was not found in the program block. The manual's first action is: “Reconsider the program.”
Tool compensation commands were issued during arc interpolation mode, which is not allowed. The manual's first action is: “Issue the linear command (G01) or rapid traverse command (G00) in the compensation command blo…
A tool radius compensation command was issued without the feature being specified in the machine's capabilities. The manual's first action is: “Check the tool radius compensation specification.”
An arc command was issued that cannot accommodate tool position compensation, violating system constraints. The manual's first action is: “Reconsider the program.”
Tool position compensation was attempted during figure rotation or program coordinate rotation, which is unsupported. The manual's first action is: “Reconsider the program.”
The tool position compensation feature is not available on this machine, as per specifications. The manual's first action is: “Check the specifications.”
A G command incompatible with G93 mode or a mode not supporting inverse time feed was issued. The manual's first action is: “Reconsider the program.”
The inverse time feed option was attempted without being supported by the machine's specifications. The manual's first action is: “Check the specifications.”
The machine detected an automatic corner override command that does not exist in the system specifications. The manual's first action is: “Check the specifications. Delete the G62 command from the program.”
A rapid traverse command (F0) was issued during a circular interpolation, which is invalid in this mode. The manual's first action is: “Rapid traverse cannot be commanded and so any F1-digit command except F0 should b…