Error, fault and alarm codes of products - what each code means, its causes and what to do - read from the manufacturers’ manuals, with the manual page each answer comes from.
All 31 error codes of the Bitzer BAO-102-1 AUS BAO-102-1 AUS controller with their meaning, causes and what to do, taken from the manufacturer's manual with page references.
An error occurred in the detector's absolute position counter. The manual's first action is: “• Replace the detector.”
The battery voltage has dropped due to detector cable wire breakage or looseness. The manual's first action is: “• Check the battery and detector cable. The zero point does not need to be initialized.”
The manual lists this code without a description. The manual lists no action for this code.
The servo ON signal was input while the main circuit power was OFF, indicating a faulty contactor operation. The manual's first action is: “• Turn ON the main circuit power.”
There is an error in the internal data of the absolute position detector. The manual's first action is: “• Take countermeasures against noise. • Replace the servomotor.”
The overload alarm 1 has occurred. The manual's first action is: “• Refer to the items for ASW0033 0050.”
The regeneration power has exceeded the tolerable range of the built-in regenerative resistor or external regenerative option. The manual's first action is: “• Lower the positioning frequency. • Change the regenerativ…
The battery powering the absolute position detection system has dropped below acceptable voltage levels. The manual's first action is: “• Mount a battery. • Replace the battery and initialize the absolute position.”
An auxiliary axis servo warning has been triggered, but no specific cause is listed. The manual lists no action for this code.
A command was issued that is illegal within cylindrical mode operation. The manual's first action is: “Reconsider the program.”
No end point coordinate command was provided for an R-designated arc in the program. The manual's first action is: “Reconsider the program.”
Reference point return was attempted while the figure was rotating, which is invalid. The manual's first action is: “Reconsider the program.”
An unused address exists in a program block that was not used during execution. The manual's first action is: “Reconsider the program.”
A G code was ignored due to priority order checks in the program. The manual's first action is: “Reconsider the program.”