Error code154
The path requires a feedforward velocity that exceeds the system's capacity. The manual's first action is: “Decrease the path demands in terms of required feedrate.”
- Model
- FAGOR MAN REGUL (IN)
- Display shows
- Excessive Feedforward velocity command. (154)
- Type
- Error code
- Source
- Manual p. 328
What 154 means
Excessive Feedforward velocity command. p. 328
Common causes
- - The path required by the position command causes a feedforward velocity command which is too high. p. 328
What to do
- Decrease the path demands in terms of required feedrate. p. 328
If 154 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.
This page summarises what the manufacturer’s manual says about 154; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.