FAGOR MAN REGUL (IN) Error 150: Travel limit overrun.

FAGOR MAN REGUL (IN) servo-drive system · taken from the manufacturer’s manual, pages cited

Error code150

Travel limit overrun error 150 occurs when the axis movement exceeds preset travel limits, requiring recheck of limit values and programming. The manual's first action is: “Check the values of these limits and the programming of these movements.”

Model
FAGOR MAN REGUL (IN)
Display shows
Travel limit overrun. (150)
Type
Error code
Source
Manual p. 328

What 150 means

Travel limit overrun. p. 328

Common causes

  • - The travel limits of the axis have been exceeded. p. 328

What to do

  1. Check the values of these limits and the programming of these movements. p. 328

If 150 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.

Open the manual at page 328 All MAN REGUL (IN) error codes Manual details & download

This page summarises what the manufacturer’s manual says about 150; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.