FAGOR MAN REGUL (IN) Error 106: Outside temperature on the heatsink. (Heatsink of the IGBTs)

FAGOR MAN REGUL (IN) servo-drive system · taken from the manufacturer’s manual, pages cited

Error code106

Error 106 indicates the drive is overheating due to excessive load or ambient temperature on the heatsink. The manual's first action is: “Stop the system for a few minutes and reduce the amount of effort required of the Drive.”

Model
FAGOR MAN REGUL (IN)
Display shows
Outside temperature on the heatsink. (Heatsink of the IGBTs) (106)
Type
Error code
Source
Manual p. 327

What 106 means

Outside temperature on the heatsink. (Heatsink of the IGBTs) p. 327

Common causes

  • - The drive is doing something which causes the power devices to overheat. p. 327
  • - The drive is exposed to excessive temperature. p. 327

What to do

  1. Stop the system for a few minutes and reduce the amount of effort required of the Drive. p. 327
  2. Cool it down. p. 327
  3. Get in touch with Fagor Automation. p. 327

If 106 is still not resolved

The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.

Open the manual at page 327 All MAN REGUL (IN) error codes Manual details & download

This page summarises what the manufacturer’s manual says about 106; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.