Error code152
The command module has received a value exceeding the limit set by parameter PP103. The manual's first action is: “Check the value of this parameter together with its equivalent parameter at the CNC. Check that both the drive and the CNC work in the same command mode.”
- Model
- FAGOR MAN REGUL (IN)
- Display shows
- Command module exceeded. (152)
- Type
- Error code
- Source
- Manual p. 328
What 152 means
Command module exceeded. p. 328
Common causes
- - While working with a command in module format, a command has been received whose value exceeds the one set by parameter PP103. p. 328
What to do
- Check the value of this parameter together with its equivalent parameter at the CNC. Check that both the drive and the CNC work in the same command mode. p. 328
If 152 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.
This page summarises what the manufacturer’s manual says about 152; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.