Error code155
The path demands an acceleration higher than what is permitted by the system settings. The manual's first action is: “Decrease the path demands in terms of required acceleration.”
- Model
- FAGOR MAN REGUL (IN)
- Display shows
- Excessive Feedforward acceleration command. (155)
- Type
- Error code
- Source
- Manual p. 328
What 155 means
Excessive Feedforward acceleration command. p. 328
Common causes
- - The path required by the position command causes a feedforward acceleration command which is too high. p. 328
What to do
- Decrease the path demands in terms of required acceleration. p. 328
If 155 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.
This page summarises what the manufacturer’s manual says about 155; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.