Error code108
Motor overtemperature error 108 is triggered by defective temperature sensors or high current peaks, requiring system pause and ventilation. The manual's first action is: “Stop the system for a few minutes and decrease the amount of effort demanded to the motor. Ventilate the motor.”
- Model
- FAGOR MAN REGUL (IN)
- Display shows
- Motor overtemperature. (108)
- Type
- Error code
- Source
- Manual p. 328
What 108 means
Motor overtemperature. p. 328
Common causes
- The cables measuring motor temperature (position sensor cables), or the thermistor itself are defective. The application requires high current peaks. p. 328
What to do
- Stop the system for a few minutes and decrease the amount of effort demanded to the motor. Ventilate the motor. p. 328
If 108 is still not resolved
The manual gives no further instruction for this code. Open the code table in the PDF or contact FAGOR service.
This page summarises what the manufacturer’s manual says about 108; each statement links to the page it comes from, and quoted lines are copied word for word. It is not a substitute for the manual or for a qualified installer. ManualLib is not affiliated with FAGOR. Found a mistake? Report an error.