Industrial

This document describes a magnetic base and dial gauge base with an articulated polished aluminium alloy arm and a central locking knob. Plunger and lever indicators can be attached using the 3/8in/8mm stem or dovetail fitting system. The arm is mounted on a powerful magnetic base with an 8mm x 1.25mm thread. The dimensions of the arm are: lower 110mm, upper 102mm, gauge holder 46mm.

L6565 is a current-mode primary controller IC, specifically designed to build offline Quasi-resonant ZVS (Zero Voltage Switching at switch turn-on) fly- back converters.

AP1533 is a PWM control 1.8A step-down converter with low ripple power, high efficiency and excellent transient characteristics. The converter contains a reference voltage source, oscillation circuit, error amplifier and internal PMOS. The PWM control circuit is able to vary the duty ratio linearly from 0% to 99%. The converter also contains an error amplifier circuit as well as a soft-start circuit that prevents overshoot at startup. An enable function, an over current protect function and a short circuit protect function are built inside, and when OCP or SCP happens, the operation frequency will be reduced from 300KHz to 50KHz. Also, an internal compensation block is built in to minimum external component count. With the addition of an internal P-channel Power MOS, a coil, capacitors, and a diode connected externally, these ICs can function as step-down switching regulators. They serve as ideal power supply units for portable devices when coupled with mobile devices.

The CY25811/12/14 are Spread Spectrum Clock Generator (SSCG) ICs produced by Cypress Semiconductor Corporation for the purpose of reducing electromagnetic interference (EMI) issues. It has a 4 to 32 MHz input frequency range, a 4 to 128 MHz output frequency range, and accepts clock, crystal, and resonator inputs. It offers 1x, 2x, and 4x frequency multiplication: CY25811: 1x; CY25812: 2x; CY25814: 4x. It supports center and down spread modulation, has low power consumption (3.3V = 52 mW-typ @ 6MHz, 3.3V = 60 mW-typ @ 12MHz, 3.3V = 72 mW-typ @ 24MHz) and low cycle-to-cycle jitter (8 MHz = 450 ps-max, 16 MHz = 225 ps-max, 32 MHz = 150 ps-max). It has 8-pin SOIC and TSSOP packages and is suitable for commercial and industrial temperature ranges.

This document is an introduction to Cypress CyAPI Programmer's Reference, which mainly introduces the related content of CCyBulkEndPoint, CCyControlEndPoint and CCyInterruptEndPoint.

This document describes the features and characteristics of the TPS6120x series products, including low input voltage, synchronous boost converter, high efficiency, overtemperature protection, etc. These products are suitable for products powered by single-cell, two-cell, or three-cell alkaline, NiCd or NiMH, or one-cell Li-Ion or Li-polymer battery.

M68HC908AS32A is a microcontroller produced by Freescale

LTC1778/LTC1778-1 1778fb No RSENSEWide Operating Range, TM Step-Down Controller is a synchronous step-down switching regulator controller without resistor, which has extremely fast transient response and stable ceramic COUT. It can be used in notebook computers and palmtop computers.

ACS754xCB-050 is a Hall current sensor produced by onsemi. It has a small size and excellent performance, which is suitable for automotive, industrial, motor control, servo system, power conversion and battery monitoring applications

The LT®6013 and LT6014 are precision op amps from Linear Technology Corporation that combine low noise and high precision input performance with low power consumption and rail-to-rail output swing.

The AD1866 is a single supply dual 16-bit audio DAC offering excellent performance while requiring a single +5 V power supply.

STN3NF06L is a N-channel 60V-0.07Ω-4A SOT-223 STripFET™ II power MOSFET from STMicroelectronics. It features a typical RDS(on)=0.07 Ω, exceptional dv/dt capability, rugged avalanche characteristics, 100% avalanche tested, and low threshold drive.

The TSUS4400 is an infrared emitting diode in standard GaAs on GaAs technology, molded in a clear, blue tinted plastic package. The device is spectrally matched to silicon photodetectors.

The LT1108 is an improved version of the LT1173, which uses a 60% duty cycle for lower power consumption and higher output current. Suitable for battery-powered systems, it can operate over a 2V to 30V voltage range and output adjustable 5V or 12V.

The C8051F040/1/2/3/4/5/6/7 is a mixed signal ISP flash MCU produced by Silicon Laboratories. Its features include a 10 or 12-bit SAR ADC, an 8-bit SAR ADC, two 12-bit DACs, three analog comparators, a voltage reference, a precise VDD monitor/brownout detector, on-chip JTAG debug and boundary scan, and a high-speed 8051µC core with pipelined instruction architecture.