Industrial

SL02 / 03 / 04 is a series of small signal Schottky diodes produced by Vishay Semiconductors, with low power loss, high efficiency, and high temperature soldering.

The TSOP62.. is a miniaturized SMD-IR Receiver Modules for infrared remote control systems, supporting all major transmission codes. It has photo detector and preamplifier in one package, internal filter for PCM frequency, continuous data transmission possible, TTL and CMOS compatibility, output active low, low power consumption and high immunity against ambient light.

The LM2771 is a switched capacitor step-down regulator that produces a 1.5V output without the use of an inductor. It is capable of supplying loads up to 250mA. The LM2771 operates with an input voltage from 2.7V to 5.5V, and requires only 3 low-cost ceramic capacitors. The LM2771 uses a regulated 0.5x charge pump to give power conversion efficiencies nearly twice as high as an LDO. Pre-regulated 1.1MHz fixed-frequency switching results in very low ripple and noise on both the input and the output. When output currents are low (<30mA typ.), the part automatically switches to a low-ripple PFM regulation mode to maintain high efficiency over the entire load range. At input voltages below 3.5V (Typ), the charge pump goes into pass mode, with efficiencies similar to an LDO. The LM2771 is available in National’s 10-pad Leadless Leadframe No-Pullback Package (LLP-10).

The LP2989 is a fixed-output 500 mA precision LDO regulator designed for use with ceramic output capacitors. Output noise can be reduced to 18µV (typical) by connecting an external 10 nF capacitor to the bypass pin. Using an optimized VIP™ (Vertically Integrated PNP) process, the LP2989 delivers superior performance.

VIS VG26(V)(S)18165C 1,048,576 x 16 - Bit CMOS Dynamic RAM is a memory product produced by VisIC. It is powered by 5V or 3.3V and works at a speed of 50/60ns. It has low power consumption (5V version 660/605 mW, 3.3V version 432/396 mW). It supports EDO page mode access, I/O level supports TTL and LVTTL, and can realize 4 refresh modes: RAS only refresh, CAS - before - RAS refresh, Hidden refresh, Self-refresh.

This is a bi-directional small form factor transceiver designed for full-duplex communication over a single fiber. The single fiber concept saves overall system costs by eliminating one fiber, allowing for doubling of capacity without installing new fibers, and simplifying fiber management.

LT1302/LT1302-5 Micropower High Output Current Step-Up Adjustable and Fixed 5V DC/DC Converters

AD8061/AD8062/AD8063 is a low-cost, 300 MHz rail-to-rail amplifier with low power consumption, low cost, high gain, high speed, low power consumption, and small packaging.

ISL6252, ISL6252A is a battery charger controller for Li-Ion/Li-Ion polymer batteries from Intersil, supporting 2, 3, and 4 series Li-Ion cells, high efficiency synchronous buck topology, low side MOSFET emulates a diode at light loads to improve the light load efficiency and prevent system bus boosting.

This document describes the contents of the Modem-DK Embedded Modem Development Kit, including development boards, adapter boards, modem boards, and software tools. This kit is used to develop embedded modem applications based on Silicon Laboratories MCU devices.

This document is about UT912D. UT912D is a CMOS LSI for remote control system applications. It can decode information which consists of N address bits and 12-N data bits.

The LT1425 is a monolithic high power switching regulator specifically designed for the isolated flyback topology. No “third winding” or optoisolator is required; the integrated circuit senses the isolated output voltage directly from the primary side flyback waveform. A high current, high efficiency switch is included on the die along with all oscillator, control and protection circuitry. The LT1425 operates with input supply voltages from 3V to 20V and draws only 7mA quiescent current. It can deliver output power up to 6W with no external power devices. By utilizing current mode switching techniques, it provides excellent AC and DC line regulation. The LT1425 has a number of features not found on other switching regulator ICs. Its unique control circuitry can maintain regulation well into discontinuous mode in most applications. Optional load compensation circuitry allows for improved load regulation. An externally activated shutdown mode reduces total supply current to 15µA for standby operation.

VISHAY SFH617A is a high-reliability optocoupler with features including 5300 VRMS isolation test voltage, 70 V high collector-emitter voltage, low saturation voltage, fast switching times, low coupling capacitance, and high common-mode interference immunity.

The CS5381 is a high performance, low power, high dynamic range 24-bit multi-bit analog-to-digital converter that can be used in digital audio systems. It uses a 5th-order multi-bit delta-sigma modulator, supports 192 kHz sampling rate, and has high-pass filter or DC offset calibration, logic level support, differential analog architecture, low-latency digital filtering, overflow detection and other features.