Industrial

This document is about the electro-optical characteristics, electrical characteristics, absolute maximum ratings of LN28RPX, LN38GPX, LN48YPX, LN88RPX. The document provides the electro-optical characteristics, electrical characteristics, absolute maximum ratings of the four products for reference.

The LMV727X series is a 1.8V low-power comparator with switch output and push-pull output. It has single power supply and dual power supply. They have low power consumption, low voltage, high performance, etc., and are suitable for low voltage, low power and space-limited designs.

The LM833 is a dual general purpose operational amplifier designed with particular emphasis on performance in audio systems. It has wide dynamic range, low noise, high gain bandwidth, high slew rate and low distortion.

The LM4881 is a dual audio power amplifier from National Semiconductor capable of delivering 200mW of continuous average power into an 8Ω load with 0.1% (THD) from a 5V power supply.

The LM224W is a high gain, low current, internally frequency compensated operational amplifier. It operates from a single power supply over a wide range of voltages. The LM224W can also be operated from split power supplies and the low power supply current drain is independent of the magnitude of the power supply voltage. All the pins are protected against electrostatic discharge up to 2000V.

The document describes the characteristics and features of three models of diodes (LL4148, LS4148, and MCL4148), including packaging and dimension information. These products are suitable for surface mount and axial lead applications.

LH7A400 is a 32-bit system-on-chip with ARM922T core, 200MHz clock, 80KB on-chip memory, support 100MHz external bus interface, clock and power management, low power mode, programmable LCD controller, DMA, AC97, MMC, USB and other functions

VISHAY LH1520AB/ AAC/ AACTR is a dual-channel solid-state relay with features such as current limit protection, isolation test voltage of 5300 VRMS, typical resistance of 20Ω, load voltage of 350V, and load current of 150mA.

LDRxxyy is a very low dropout dual voltage regulator suitable for low noise and low power applications such as PDA, MICRODRIVE, and other data storage applications, as well as consumer applications such as monitors and set-top boxes. It features very low dropout voltage, very low supply current, and logic-controlled electronic shutdown function.

This product is a 10/100Mbps fast Ethernet controller with PCI bus interface, supports PCI 2.1 standard, supports CardBus status registers, supports two-channel bus master, supports scatter/gather DMA function, supports pre-fetch interrupt support, supports Wake-Up on Magic Packet TM detection and network link down event, supports chained transmission data packets, supports early transmit and early receive, supports optional early receive buffer mode, supports automatic rejection of small packets, supports automatic retransmission of collision frames, supports automatic padding of short frames, supports 4.5K bytes of receive buffer and 1.5K bytes of transmit buffer, supports optional 32-bit wide external receive buffer, supports big/little endian byte order, supports 64K bytes of expansion boot flash RAM

The 308 VWI 20-06P1 is a Sixpack IGBT module with NPT IGBTs and FRED diodes, and it is suitable for applications such as AC drives and power supplies with power factor correction.

The L4974A is a 3.5A switching regulator with an output voltage range of 5.1V to 40V, a duty cycle range of 0 to 90%, internal feed-forward line regulation, internal current limiting, precise 5.1V ± 2% on-chip reference, reset and power fail functions, input/output sync pin, under-voltage lockout with hysteric turn-on, PWM latch for single pulse per period, very high efficiency, switching frequency up to 200KHz, thermal shutdown, and continuous mode operation.

Am29LV128MH/L is a 128M-byte flash memory chip produced by AMD. Its features are single power supply, 3 volts to read, write and erase, and uniform sectors and easy programming.