Industrial

This datasheet lists detailed specifications of the BAS70W/ -04/ -05/ -06 Schottky barrier diodes, including package, pins, dimensions, electrical parameters, etc.

This document is the technical data manual of EPCOS AG's B78386P1648A005 type ISDN transformer UK0 interface

This document describes the typical applications, climatic conditions, construction, features, terminals, marking and delivery conditions of B32632 . B32634 series/type metallized polypropylene film capacitors (MFP)

This document is the Site Preparation Guide for Agilent Technologies' 5973N and 5973 inert Mass Selective Detectors. It describes the features and characteristics of the products.

This document describes the use of the Agilent Technologies Active Seal Wash Option, including its features, installation, and parts list.

B10011S is a CAN bus system transceiver with high output voltage. It is designed for point-to-point interface between truck and trailer according ISO WD 11992-1

This document describes the features and characteristics of ZETTLER electronics' AZ850 microminiature polarized relay, including small size, high sensitivity, options of monostable and bistable versions, compliance with FCC Part 68.302 1500 V lightning surge, etc.

Technical parameters of AZ833 relay, including rated load, contact structure, coil voltage, life, working temperature, etc.

This document mainly introduces the features and characteristics of ASIX AX88615P 5-Port 10/100BASE Ethernet Switch.

The document describes the features and characteristics of the ATF16V8B high-performance CMOS programmable logic device, including industry-standard architecture, high-speed electrically erasable programmable logic devices, several power-saving options, CMOS and TTL compatible inputs and outputs, advanced Flash technology, high reliability CMOS process, etc.

This high-density, high-performance electrically-erasable complex programmable logic device has a 3.0 to 3.6V operating range, 32 macrocells, 5 product terms per macrocell, expandable up to 40 per macrocell, 44 pins, 15 ns maximum pin-to-pin delay, registered operation up to 77 MHz, and enhanced routing resources.

The AT49F010/HF010 1-Megabit (128K x 8) 5-volt Only CMOS Flash Memory is an in-system programmable and erasable Flash Memory manufactured by Atmel. Their 1-megabit of memory is organized as 131,072 words by 8 bits. Manufactured with Atmel's advanced nonvolatile CMOS technology, the devices offer access times to 45 ns (HF version) with a power dissipation of just 165 mW over the commercial temperature range. When the device is deselected, the CMOS standby current is less than 100 µA. To allow for simple in-system reprogrammability, the AT49F010/HF010 does not require high input voltages for programming. Five-volt-only commands determine the read and programming operation of the device. Reading data out of the device is similar to reading from an EPROM. Reprogramming the AT49F010/HF010 is performed by erasing the entire 1 megabit of memory and then programming on a byte by byte basis.

The AT49F004(T) and AT49F4096A(T) are 5-volt, 4-megabit Flash Memories orga- nized as 524,288 words of 8 bits each or 256K words of 16 bits each. Manufactured with Atmel’s advanced nonvolatile CMOS technology, the devices offer access times to 55 ns with power dissipation of just 275 mW. When deselected, the CMOS standby current is less than 300 µA. The device contains a user-enabled “boot block” protection feature. Two versions of the feature are available: the AT49F004/4096A locates the boot block at lowest order addresses (“bottom boot”); the AT49F004T/4096AT locates it at highest order addresses (“top boot”). To allow for simple in-system reprogrammability, the AT49F004(T)/4096A(T) does not require high input voltages for programming. Reading data out of the device is similar to reading from an EPROM; it has standard CE, OE, and WE inputs to avoid bus con- tention. Reprogramming the AT49F004(T)/4096A(T) only requires one pin, CE. For most operations, the other pins are in high-impedance state.

AT-358 T0-8-2 is a 1-bit, 10 dB, GaAs digital attenuator that operates in the frequency range of 0.02-2GHz.

The AT34C02B is a serial electrically-erasable and programmable read only memory (EEPROM) with 256 x 8 bits organization. It features permanent and reversible software write protection for the first-half of the array, hardware write protection for the entire array, low-voltage and standard-voltage operation, two-wire serial interface, bidirectional data transfer protocol, and compatibility with different clock speeds. It also has high-reliability with endurance of 1 million write cycles and data retention of 100 years. The package options include JEDEC SOIC, Ultra Thin Mini-MAP (MLP 2x3), TSSOP, and dBGA2.