Industrial

The DGP12 Series dual output power supply provides symmetrical +/– outputs from 5 volts to 15 volts in packages that provide power densities up to 7 watts per cubic inch (0.43 watts per cm3). Designed to operate on ultra-wide input voltages from 3.5 to 16 volts, and with remote ON/OFF capability, the DGP12 supplies power from battery or system sources. The fully isolated, shielded case allows precise operation in sensitive environments.

This document is an introduction document about DAC8143 12-Bit Serial Daisy-Chain CMOS D/A Converter, which introduces the features and characteristics of the product

The G1847A is a GPIB/RS-232 MIO card that allows the host computer to communicate with the 35900E through either an RS-232 or a GPIB connection. Precautions should be taken during installation to avoid static electricity and damage to the card's components. The installation steps include turning off the power, removing the power supply cord, removing the existing card or cover, inserting the new card, and securing it with thumb screws.

This manual introduces the Agilent 6850 Gas Chromatograph Direct Valve–Column Connector Kit G2630-61710, including the components of the connector, installation steps and precautions.

This document describes how to use software utilities to reset the random access memory (RAM) of the Agilent G2890/G2891 Micro Gas Chromatograph

Agilent 35900E Dual Channel Interface Service Manual, introduces the maintenance information of the 35900E dual channel interface product, including basic information, fault diagnosis, maintenance steps, etc.

D171-Type FastLight ™ PIN Photodetectors are a type of infrared sensor produced by Lucent Technologies. It has the characteristics of low power consumption, fast response, and high sensitivity.

The CYM1465 is a high-performance 4-megabit static RAM module organized as 512K words by 8 bits, which is produced by Cypress Semiconductor Corporation. It features high density, high speed, low power consumption, 2V data retention, JEDEC-compatible pinout, 32-pin, 0.6-inch-wide DIP package, TTL-compatible inputs and outputs, low profile, and small PCB footprint.

This document describes the 64 x 4 and 64 x 5 cascadable FIFO memories from Cypress Semiconductor Corporation. They are processed with high-speed CMOS for optimum speed/power and support 25MHz data rates. The FIFOs are expandable in word width and/or length, have independent asynchronous inputs and outputs, and a TTL-compatible interface, among other features.

This datasheet provides information on the features, pinout, speed, drive capability, temperature range, and power supply voltage of the CY54/74FCT240T and CY54/74FCT244T

The CXP843P40 is a CMOS 8-bit single chip microcomputer that integrates an A/D converter, serial interface, timer/counter, time base timer, capture timer/counter, and remote control reception circuit, in addition to the basic configurations of an 8-bit CPU, ROM, RAM, and I/O port. The CXP843P40 also provides a sleep/stop function for lower power consumption. This IC is the PROM-incorporated version of the CXP84340 with built-in mask ROM, allowing direct writing into the program. It is most suitable for evaluation use during system development and for small-quantity production.

The CXG1040TN is a DPDT (Dual Pole Dual Throw) antenna switch MMIC from Sony that is used in Personal Communication handsets such as PCS. This IC is designed using Sony's GaAs J-FET process and operates with CMOS input. The product has the characteristics of CMOS input control, insertion loss of 0.5 dB (typical) at 2.0 GHz, high isolation of 25 dB (typical) at 2.0 GHz, and a small package TSSOP-10pin.

CXG1030N is a power amplifier from Sony. This IC is designed using the Sony’s GaAs J-FET process and operates at a single power supply. It features output power of 21 dBm, positive power supply of 3.0 V, low current consumption of 170 mA, and high power gain of 39 dB Typ.

This document provides the installation guide for the Agilent 7683 Automatic Liquid Sampler. The product is classified as Safety Class 1, Transient Overvoltage Category II, and Pollution Degree 2. The document also includes safety information and warnings.