Industrial

The ST24/25E64 are 64K bit electrically erasable programmable memories (EEPROM), organized as 8 blocks of 1024x8 bits. The ST25E64 operates with a power supply value as low as 2.5V. Both Plastic Dual-in-Line and Plastic Small Outline packages are available.

This document describes a C++ preprocessor called ST20-SWC++, used for programming ST20 and T4/T8 transputers. It supports features such as hardware run-time kernel, interactive symbolic debugging, EPROM programming, and is suitable for embedded systems, software porting, evaluation of ST20 and transputer processors, and scientific programming.

SP809/SP810 are low power microprocessor (µP) supervisory circuits used to monitor power supplies in µP and digital systems. They provide applications with benefits of circuit reliability and low cost by eliminating external components. If the VCC supply voltage falls below preset threshold then a reset signal is asserted for at least 140ms after VCC has risen above the reset threshold. Both the SP809 and SP810 were designed with a reset comparator to help identify invalid signals, which last less than 140ms. The only difference between them is that they have an active-low RESET output and active-high RESET output, respectively. Low supply current (1µA) makes SP809/SP810 ideal for portable equipment. The devices are available in 3 pin SOT-23 package.

The SP1085 is a 3A low dropout linear regulator with a maximum dropout of 1.5V. It is available in 1.5V, 1.8V, 2.5V, 2.85V, 3.3V, 5.0V and adjustable versions. The fixed versions integrate the adjust resistors. The adjustable version can set the output voltage with two external resistors. The SP1085 series is available in standard packages of TO-263-3L, TO-220 and TO-252.

SCBS682G is an octal buffer/driver with support for mixed-mode signal operation. It supports 5V input and output voltages as well as a 3.3V VCC voltage. It features low output ground bounce, support for unregulated battery operation, power-up 3-state support hot insertion, bus hold on data inputs, and more.

The SN74ALVC14 is a six-way Schmitt trigger inverter produced by Texas Instruments. It operates at a voltage of 2.3V to 3.6V and a temperature of -40℃ to 85℃.

SN54AHCT595, SN74AHCT595 are 8-bit serial-in, parallel-out shift registers with 3-state output registers.

This document introduces the features, specifications, dimensions, and performance of the SMA series surface-mounted unidirectional and bidirectional transient voltage suppressors.

The SM8S Series is Vishay Semiconductors’ (formerly General Semiconductor’s) new line of Surface Mount Automotive Transient Voltage Suppressors, with Stand-off Voltages from 10 to 43V, Peak Pulse Power of 6600W (10/1000µs) and 5200W (10/10,000µs)

The Sanken Power Devices 28210.05 SLA7075M, SLA7076M, SLA7077M, and SLA7078M Motor Drivers are a family of 2-phase stepper unipolar drivers. They feature a clock-in type input interface that allows simplified control logic, and options for built-in sense current detection and load circuit short or open protection (patent pending) provide lower loss and lower thermal resistance. All products in the SLA7070M series are pin-compatible, supporting rapid design of application variants. The built-in excitation distribution circuit (sequencer) allows motor control using only the CLOCK signal for simple operations (rotate/stop), with motor speed control by frequency input into CLOCK pin. This eliminates logic signal lines required for conventional phase-input methods, and reduces demand on heavily-used CPUs.

This document describes the features and characteristics of the FDH700 ultra fast diode from Fairchild Semiconductor Corporation, including maximum junction temperature, total power dissipation, working inverse voltage, and forward current.