Kingston KVR2G Manuals

This document describes ValueRAM’s 256M x 64-bit 2GB (2048MB) DDR2-800 CL6 SDRAM (Synchronous DRAM) memory module.

This is a 256M x 64-bit (2GB) DDR2-800 CL6 SDRAM (Synchronous DRAM) 2Rx8 240-Pin DIMM memory module

The KVR1333D3N9K2/2G 2GB (1GB 1Rx8 128M x 64-Bit x 2 pcs.) PC3-10600 CL9 240-Pin DIMM Kit is a ValueRAM memory module that uses DDR3-1333 memory. It has a single capacity of 1GB and a total capacity of 2GB. It supports CAS latency 9, 8, 7, 6. It supports 8 independent internal banks, Burst Length 8 and 4, Asynchronous Reset, On Die Termination using ODT pin, Bi-directional Differential Data Strobe, Internal self calibration through ZQ pin (RZQ : 240 ohm ± 1%) and Average Refresh Period 7.8us at lower than TCASE 85°C, 3.9us at 85°C < TCASE < 95°C.

This document describes ValueRAM's 256M x 64-bit 2GB (2048MB) DDR2-800 CL5 SDRAM (Synchronous DRAM) memory module. The components on this module include sixteen 128M x 8-bit DDR2-800 SDRAM in FBGA packages. This 240-pin DIMM uses gold contact fingers and requires +1.8V.

This is the specification sheet for ValueRAM's 256M x 64-bit (2GB) DDR3-1333MHz CL9 SDRAM (Synchronous DRAM) memory module, based on sixteen 128M x 8-bit DDR3-1333MHz FBGA components. The SPD is programmed to JEDEC standard latency 1333MHz timing of 9-9-9 at 1.5V. This 204-pin SODIMM uses gold contact fingers and requires +1.5V. The electrical and mechanical specifications are as follows:

KVR1066D3S8N7/2G 2GB 1Rx8 256M x 64-Bit PC3-8500 CL7 240-Pin DIMM is a DDR3-1066 CL7 SDRAM (Synchronous DRAM) from ValueRAM, a 1Rx8 memory module based on eight 256M x 8-bit DDR3-1066 FBGA components. The SPD is programmed to JEDEC standard latency DDR3-1066 timing 7-7-7 at 1.5V. This 240-pin DIMM uses gold contact fingers.